This is the metal touch sensor module. This sensor is an electronic switching device. Basically, it will operate when touched by a charged any part of the body it triggers a high frequency which is generated by the transistor that conducts an electrical pulse when to receive an electromagnetic signal. See below for the wiring guide.
Required Components.
- Arduino UNO, MEGA, DUE, LEO, NANO, PRO, ESP8266 13, 12, 7, 11.
- LED (Any Color)
- Resistor 200 Ohms
- Solder Less Bread Board
- Jumper Wire
Wiring Diagram
Source Codes / Sketch Code for Digital
[crayon-6729821735aa0244375467/]
Source Code / Sketch Code for Analog
[crayon-6729821735aaa207029428/]
Wiring the Metal Touch Sensor Module with MCU
