This is the D7S Seismic Earthquake Sensor. D7S sensor uses 3-AXIS acceleration sensor developed by OMRON’s unique SI (Spectral Intensity) value calculation algorithm which it has a high correlation with SIS Seismic Intensity Scale that indicates the magnitude of an earthquake that provides higher precision of seismic intensity. This sensor has two opendrain output in pin INT1 and INT2 that turns active into LOW when it’s off condition and collapse detection condition when detected at intensity 5 or higher, the INT2 goes active LOW during earthquake calculation for offset acquisition and self-diagnostic handling. This device use i2C for communication with the sensor for settings and tracking down earthquake related information. The sensor is useful on fire prevention, secondary disaster after an earthquake hits.
Required Component to Test
- Arduino Microcontroller, NodeMCU, Teensy Board, TeensyDuino, ESP8266 12, 12E, ESP8266 NodeMCU, ESPDuino, ATMEGA328 16/12, ATMEGA32u4 16/8/ MHz, ESP8266, ATMEGA250 16 MHz, ATSAM3x8E, ATSAM21D, ATTINY85 16/8 MHz (Note: The Diagram below is using NANO. (please refer to the respective pin-outs)
- D7S Seismic Sensor
- 10uf Capacitors (Optional)
- 10k Resistors
- Jumper Wires / DuPont Wires
- Prototyping PCB board (for soldering manually)
Wiring Guide
Source Code
[crayon-678f2ad45dd73238240410/]
[crayon-678f2ad45dd7c015270203/]
i2C/TWI Scanner
[crayon-678f2ad45dd80999941304/]
Downloads
- Download D7S Vibration Sensor Datasheet | PDF
