The Analog Devices ADuM340E / ADuM341E / ADuM342E is an isolated high-speed, voltage-mode, single-channel digital isolator based on Analog Devices, Inc., iCoupler® technology. It uses an integrated transformer to provide galvanic isolation of up to 2500V RMS for 2 seconds.
Wiring the 128×64 1.3 inch OLED Display on 4 Wire, 3 Wire, i2C Interface
This is the 1.3 inch OLED Display driven by SH1106 from Waveshare, 128×64 resolution, it has integrated 3 interface the 3 wire SPI, 4 wire SPI, and i2C for ease integration in your microcontroller. This OLED is mainly runs by
Wiring the PCF8574AP 8bit Bidirectional IO Expander Driven i2C Communication Bus / SPI
This is the PCF8574AP consists of an 8-bit quasi-bidirectional port and an i2C Serial Bus Interface. The PCF8574AP has a low current consumption and includes latched output with HIGH consumption and include latched output with high current drive capability for
Wiring the I2C / SPI OLED Monochrome Display with RPI
Another guide for wiring the OLED 128×64 Display Monochrome on Raspberry Pi. These display module has only 0.96” diagonal made of 128×64 OLED pixels, this module it works without backlight can be visible in the dark environment, and OLED display
Wiring the MCP2515 Stand-alone CAN Controller with SPI
This is an illustration how CAN (Controller Area Network) protocol interface works with Microcontroller. CAN protocol is methodology of communication between electronics devices, commonly found in Automotive, these device is the responsible for the car engine management system, Gear Control,
Wiring DIGISPARK ATTINY85 with 096″ OLED Display Screen
In this illustration we will going to wire the ATTINY85 to control the OLED Screen using i2C Bus on ATTINY85 Microcontroller, I will just give an introduction what is ATTNY85 Microcontroller. The ATTINY 25,45, and 85 is a low power