LED on LUA Script | 14core.com

To upload a code to ESP8266, you should connect your ESP8266 to your FTDI USB Programmer: as the image illustration below. Coding Your fist LUA Script a blinking an LED

-- your first lua script working on LED

lighton=0
pin=4
gpio.mode(pin,gpio.OUTPUT) -- Assign GPIO to Output
tmr.alarm(1,2000,1,function()
    if lighton==0 then
        lighton=1
        gpio.write(pin,gpio.HIGH) -- Assign GPIO On
    else
        lighton=0
         gpio.write(pin,gpio.LOW) -- Assign GPIO off
    end
end)

-- your first lua script working on LED

lighton=0

pin=4

gpio.mode(pin,gpio.OUTPUT) -- Assign GPIO to Output

tmr.alarm(1,2000,1,function()

if lighton==0 then

lighton=1

gpio.write(pin,gpio.HIGH) -- Assign GPIO On

else

lighton=0

gpio.write(pin,gpio.LOW) -- Assign GPIO off

end

end)

Burning your code into the chip ESP8266 +

Important Cookie Information :