In this illustration we will going to wire the analog base temperature sensor module, this module is based on thermistor, a NTC Thermistor with a Multi-point temperature measurement to -55 Degree Celsius up to +125 Degree Celsius and has accuracy
Wiring the Vibration Sensor Switch Module on Arduino
In this illustration we will going to wire the vibration switch module, this module is default OFF when external vibration force or a movement speed from the sensor, a conductive pin will switch ON change the electrical property of the
Wiring the LCD 16×2 Keypad Shield on Arduino
In this illustration we will going to wire the 16X2 LCD Keypad Shield build for Arduino UNO, MEGA, Leonardo, this board has 4 bit Arduino LCD Library. The keypad shield has select left, up, down and right push button apart
Write your own code library on Arduino
One of the most popular library used largely in Arduino is wire.h library its actually easy to use. The wire library is created on Object-Oriented C ++ class library, most Arduino user they are not familiar with the implementation details
Wiring & Data Reading with SD Card Module
In this illustration we will going to wire the Arduino SD Card Module along with Arduino UNO and MEGA 2560 microcontroller board. We will going to transfer a data from standard SD card to our PC vise-versa. As you can
Wiring the NRF24L01 2.4GHz Radio as Remote Switching
In this illustration we will going to wire the Arduino Board to build a remote switching using the NORDIC NRF24l01 2.4GHz Transceiver. The NRF24l01 will act as a remote controller to other NRF24L01. Both the master and the slave will
Wiring the solenoid with TIP120 Transistor To Higher Load
In this illustration we will going to drive the solenoid with the input voltage of 12v to 24v using TIP120 Transistor. Because Arduino can only support power output of 3.3 and 5v this is not enough to work with the
Wiring I2C module on 16×2 LCD with SCL/SDA
In this illustration we will going to wire the I2C or 2 wire connection in our Aruduino Board with the 16×2 Liquid Crystal Display, you can also use the 20×4 LCD, but on this demonstration we will going to wire
Protecting your IO (Input Output) using Zener Diode
In a electronic system there are some inputs that controlled by the end user, these inputs are read by electronics and acted as an output. The inputs can come from a source, switches, buttons, sensors, relays, and communication device, etc.
Using Password Access Control on Matrix Keypad with Optocoupler Relay
These tutorial will guide you to make a password access control using “Keypad Membrane” connected to a Relay Module, Were just temporarily used LED for the output just to check if it is working, instead using a mechanical solenoid door