In this illustration we will going to wire the ATTINY85 to control the OLED Screen using i2C Bus on ATTINY85 Microcontroller, I will just give an introduction what is ATTNY85 Microcontroller. The ATTINY 25,45, and 85 is a low power
Wiring a Metal Detector with NPN Proximity Sensor on Arduino
In this illustration we will going to wire the NPN Inductive Proximity Sensor to detect metal or any metal objects, this device also can be used as a metal detector screening when people walking through the entrance to find metal
Setup & Installing ARM STM32FXXX DEV Board on Arduino IDE
This is a guide how to program & setup the ARM STM32F103C8T6 on Arduino IDE with STM32duino Code Library. This is the ARM STM32XX medium density performance line family incorporates the high performance ARM CORTEX M3 32Bit RISC Core Operating
Wiring SIM900 GSM/GPRS Shield with TTL / UART Serial Bus
In this illustration we will going to wire the SIM900 GSM/GPRS Shield using USB to TTL / UART and Arduino Microcontroller. The SIM900 an ultra-compact and reliable wireless module a complete Dual-Band GSM/GPRS module in a SMT type device. This
Wiring 2 or More I2C devices as Writer/Slave Receiver
In this illustration we will going to wire 2 or more Arduino board using i2c. Arduino board share information with each other on 2 wires CLS, and SCL. below are the example how to used them and programmed to communicate
Wiring the E18-D80NK Infrared Distance Ranging Sensor
In this illustration we will going to wire the Infrared distance switch, a high-sensitive photoreflector to detect distance function, ranging from 3cm to 80cm. When the infrared emitted by the emitter it will get reflected on a surface blocked it
Make your own sound activated switch on Arduino
In this illustration we will going to wire the microphone module, relay and the Arduino board. These project is compatible on most common microcontroller, the main objective of this project to make a sound activated switch or a clap switch.
Wiring the MCP2515 Shield with OBD on Arduino
In this illustration we will going to wire the CAN BUS (Controller Area Network Bus) Shield with Arduino, if you don’t have any background how CAN (Controller Area Network Bus) works please refer this this link. As you can see
Wiring the MCP2515 Controller Area Network CAN BUS Diagnostics
In this illustration we will going to wire the MCP2515 CAN BUS Breakout Module, MCP2515 is a standalone controller area network or CAN manufactured by Microchip semiconductor, that implements the CAN specification version 2.0B it is capable of transmitting and
Wiring the SIM900A GSM/GPRS Development Board
In this illustration we are going to wire the SIM900A an ultra-compact and reliable wireless module. The SIM900A is a complete Dual-Band GSM/GPRS module in a SMT type device. These SIM900A delivers GSM/GPRS 900/1800MHz performance for voice, SMS, data, and
Using 2.5 inch TFT Touch LCD Screen Shield
In this guide we will going to configure the TFT Touch Screen LCD Module in Arduino UNO, supported also working on Arduino 2560 MEGA MCU Board, These 2.4 inch TFT Touch Screen Module shield with Micro SD slot is specially
Installing & Bootloading Micro Mini Pro ATMEGA32U4 5V 16MHz
I this illustration we will going to install and configure the newly Micro Mini Pro Microcontroller Board. This board can run as Leonardo bard or using boot load SF32U4 boards. Below are the steps how to install and configure using