In these illustration we will going to wire the Hall-Effect Switch in our Arduino board. Hall-effect switch are monolithic integrated circuit with tither magnetic specification, designed to operate continuously over temperature +150 degree Celsius and are more stable with both
Didispark ATTiny85 with Ultrasonic HC SR04 Sensor
In this illustration we will going to wire the Digispark ATTiny Development Board with HC-SR04 Ultrasonic range detector, as our output we will going to use an RGB LED when the objects is near or closer to the sensor the
Mixing Color with 3 LED using Pulse with Modulation
In this tutorial we will going to mix the Red LED Green LED and Blue LED by adjusting the brightness on each LED using Pulse with Modulation capabilities of the ATMEGA chip. Parts Required Arduino UNO/MEGA/NANO 1x RED LED 1x
Breathing / Pulsating LED with Arduino
In this demonstration we will going to drive the LED on breathing / pulsing effect simply turn the LED on or off while adjusting the brightness. Required Parts Arduino UNO/MEGA/NANO/PRO LED Any cor 220 k Ohms Resistor Wiring the LED
LED Running Light or Chasing Light Effect
On tutorial we will going to make a chasing LED, we will going to wire 10 LED to make an LED chase effect, similar to that used on the bikes and cars knight riders. Electronic parts required Arduino UNO/MEGA/MINI/NANO 10x
Starter #20 Common Error of Arduino IDE
Sometimes you will encounter an errors wile your in the Arduino IDE, some error sometimes it very difficult to fix like java applet errors some error are easy to fix. below are the list of error while your doing you
How to wire the DS18B20 Temperature Sensor Module on Arduino
This demo i will going to show you how to wire the DS18B20 Temperature Sensor on Arduino using library to communicate and acquire a data on DS18B20 Dallas Semiconductor Temperature Sensor. The DS18B20 is a three pin transistor like chip,
Your First Code “Hello! 14Core” in Arduino
Your First Code “Hello! 14Core” in Arduino 1. Download and install the Arduino development environment board. 2. Connect the Arduino board with a USB cable to a PC/MAC and install drivers 3. Open the Arduino application 4. Select your board