This is the PCF8591 a single chip single supply, low power 8bit CMOS data acquisition device with four analog inputs. 1 analog output and i2c Serial communication bus interface that allows the connection to be connected in series integrated bus
Wiring with TCRT5000 Reflective Optical Sensor Module on Raspberry Pi
This is the Line Tracking Sensor designed for line following robots. The board has two main components IR Transmitter and IR Receiver in one package named TCRT5000. The TCRT5000 are reflective sensors which include an infrared emitter and photo-transistor in
Wiring the IR Flame Detection Sensor with SBC Single Board Computer
This is the Flame detection sensor its detect 60 degree angle spectral sensitivity of 720-1100nm. The spectral sensitivity of this sensor is optimized to detect emissions from naked flames. The output signal DO is pulled on a high state (active
Wiring the 360 Rotary Encoder on C Code & Python
Another illustration that demonstrate using rotary encoder. Rotary encoder is an electro mechanical device that convert the angular position or a motion of a shaft or axle to analog or digital code. Rotary encoder are usually used at the side
Wiring The 3144 Hall Effect Sensor with Raspberry Pi
Linear Sensor are critical to the performance to their sensitivity and linearity over their specified operating temperature range and immune to most environmental disturbance that may affect optical or mechanical devices, such as vibration, moisture, dirt or oil films, ambient,
Wiring Reed Switch Module with Arduino Microcontroller
On this illustration we will going to wire the Reed Switch Module. This module provides an analog as well as digital interface, as you can see on the board it has a potentiometer / trimmer used as a pull up
Wiring The Laser Transmitter on Photocell with Microcontroller
Another illustration how to build a simple physical intrusion detection with laser and photoresistor (or light-dependent resistor, LDR, or photocell). This guide shows how to wire and build a laser tripwire that triggers an alarm or output when the laser