IR Light reflection switch, useful for obstacle avoidance or line following, for obstacle avoidance you can place this module in front of the sender /receive diodes that will cause the out pin to be pulled low at distance of 1cm.
Wiring Photo Interrupter Light Blocking Switch with Raspberry Pi
photo interrupter is transmission type photo sensor that integrates optical receiving and transmitting elements in a single package please see the diagram below. Since the method involves light blocking commonly named photo interrupter. A long life infrared photo diodes is
Wiring the 360 Rotary Encoder on C Code & Python
Another illustration that demonstrate using rotary encoder. Rotary encoder is an electro mechanical device that convert the angular position or a motion of a shaft or axle to analog or digital code. Rotary encoder are usually used at the side
Wiring the Metal Touch Sensor Module with MCU
This is the metal touch sensor module. This sensor is an electronic switching device. Basically, it will operate when touched by a charged any part of the body it triggers a high frequency which is generated by the transistor that
Wiring Reed Switch Module with Arduino Microcontroller
On this illustration we will going to wire the Reed Switch Module. This module provides an analog as well as digital interface, as you can see on the board it has a potentiometer / trimmer used as a pull up
Wiring the TCRT5000 Reflective Optical Sensor Module
This is the Line Tracking Sensor designed for line following robots. The board has two main components IR Transmitter and IR Receiver in one package named TCRT5000. The TCRT5000 are reflective sensors which include an infrared emitter and photo-transistor in