NTP (Network Time Protocol) is a clock protocol that synchronize between servers and computers system, attach to the data networks. NTP was designed by David Millis at the University of Delaware. NTP is envisioned to synchronize all participating computers of
Wiring the VL53L0X ToF Accurate Laser Ranging / Distance Measuring Sensor on Microcontroller
This is the VL53LOX breakout module a type of ToF (Time-of-Flight) laser ranging sensor in smallest package capable of delivering accurate distance measurements whatever the object reflectance compared to conventional measuring sensor, the VL53LOX can measure a distance up to
Wiring the MLX90614 Infrared Contactless Temperature Measurement Sensor on Microcontroller
This Is an Infrared thermometer a non-contact temperature measurement sensor develop by Melexis microelectronics integrated system, code name MLX90614. The MLX90614 has thermopile detector chip and the signal conditioning ASSP are integrated in a low noise amplifier, 17 bit ADS
Write/Read Data to EEPROM – XC8 and PIC18F Microcontroller
There are three types of memories in a PIC Microcontroller, The Flash Program Memory, The Data Memory (RAM) and The EEPROM Data Memory. The code that is written by the user to perform a specific task by the MCU is
Wiring HC-21 (M02) 2.4GHz Wi-Fi Serial Universal Asynchronous RX/TX on Microcontroller
This is the HC-21 an embedded Wi-Fi UART module built IEEE802.11 wireless network protocol stacks and TCP/IP protocol to achieve conversation between serial data to wireless network communication. The HC21 can be connected via wireless to wireless without any support
Free Open Source SCADA (Supervisory Control and Data Acquisition) for your SBC / MCU
SCADA is a system software and hardware elements, allows industrial to control a process locally or remote locations in a real time data, directly interact with devices such sensors, valves, pumps, motors, and more through HMI (Human Machine Interface), Smart
Wiring Xtrinsic MAG3110 3-AXIS Digital Magnetometer on Microcontroller
This is a Freescale’s three axis, digital magnetometer MAG3110 is a low-power to adopt & reads an orientation an independent electronic compass that can be provide accurate heading information. It uses 400 kHz fast mode i2C serial interface output and
Wiring The LIDAR (Light Detection and Ranging Sensor) Remote Sensing with Micro-controller
This is another illustration that demonstrate how to wire the LIDAR Sensor on your Microcontroller. LIDAR (Light Detection and Ranging) is a remote sensing device which is capable capture geographical information. LIDAR data is often collected by the survey of
Wiring the PCF8591 Digital to Analog Conversion with Microcontroller
This is the PCF8591 a single chip single supply, low power 8bit CMOS data acquisition device with four analog inputs. 1 analog output and i2c Serial communication bus interface that allows the connection to be connected in series integrated bus
Wiring the APDS 9930 Ambient Light Sense / APDS 9960 RGB Gesture Sensor with Microcontroller
This is the touch-less gestures sensor a HMI (Human Machine Interface) by swiping your hand over the sensor, which controls a computer, microcontroller, robots or home, automotive, industrial gesture switching or ambient light and color measuring and proximity detections. The
Wiring the i2C INA219 ZERO Drift, Bidirectional Current/Power Monitor with MCU
This is the INA219B breakout module to measure both high side voltage and DC current draw over i2C with 1 percent precision. Current measuring devices such as current panel meter are good only for low side measuring it means that
Wiring a Stand Alone ATMEGA328P CMOS 8Bit Microcontroller
The ATMEGA328P is a CMOS 8Bit Microcontroller based on the AVR enhanced RISC architecture by executing powerful instructions in a single clock cycle. The ATMEGA328P achieves throughout put close to 1MIPS per MHz this empowers system designer to optimize the