Wiring 2N7000 AN10441 as Logic Level Converter for i2C Protocol Devices

Other micro-controller uses 5v as standard input voltage, many latest device modules, popular sensors, GPS, RF modules, Flash Memories, SPI storage, Display, use 3 to 3.3v  most of this devices requires logic level conversion to protect them from high voltage

Wiring the VL53L0X ToF Accurate Laser Ranging / Distance Measuring Sensor on Microcontroller

This is the VL53LOX breakout module a type of ToF (Time-of-Flight) laser ranging sensor in smallest package capable of delivering accurate distance measurements whatever the object reflectance compared to conventional measuring sensor, the VL53LOX can measure a distance up to

Wiring The LIDAR (Light Detection and Ranging Sensor) Remote Sensing with Micro-controller

This is another illustration that demonstrate how to wire the LIDAR Sensor on your Microcontroller. LIDAR (Light Detection and Ranging) is a remote sensing device which is capable capture geographical information. LIDAR data is often collected by the survey of

Wiring the ITG3200 / ADXL345 / HMC5883L 9DOF RAZOR IMU AHRH UART SPI i2C Communication

This is the 9DOF (Degrees Of Freedom) IMU (Inertial Measurement Unit) module that has 3 integrated sensor in one module board the ITG-3200 (Triple Axis Digital Output Gyroscope), ADXL345 (13bit Resolution ±16g Triple Axis Accelerometer), HMC5883L (Triple Axis, Digital Magnetometer)

Wiring the PCF8591 Digital to Analog Conversion with Microcontroller

This is the PCF8591 a single chip single supply, low power 8bit CMOS data acquisition device with four analog inputs. 1 analog output and i2c Serial communication bus interface that allows the connection to be connected in series integrated bus