This is the 14core design Obstacle Avoidance BOT with L293D Shield and HC-SR04 and Servo, which is capable of avoiding obstacles using an Ultrasonic Ranging Sensor. The HC-SR04 is economical sensor provides 2cm to 400cm of non-contact measurement functionality with
14CORE Line Following BOT with TCRT5000/L298N on Microcontroller
This is the 14CORE Design Line Following robot which is capable of detecting lines and follow it. This robot uses TCRT5000 Sensor which is capable of emitting dark color lines. The TCRT5000 are reflective sensors which include an infrared emitter
14CORE Light Tracking/Finder BOT on L298N / L293D with Microcontroller
ÞThis is the 14CORE Design light finder robot which is capable of detecting, finding and following light source path. This robot uses LDR (Photodiodes) to detect light from the surroundings and follow where the light source. As you can see
Wiring the Bluetooth HC06 / 4 Channel Relay Switching with Android
Another guide how to wire the HCo6 and 4 Channel Relay for switching, The HC06 modules uses BlueCore is a single chip radio and baseband IC for Bluetooth 2.4GHz system including enhance data rates (EDR) to 3Mbps. for more details
Wiring TCRT5000 IR Tracking Sensor with Raspberry Pi
IR Light reflection switch, useful for obstacle avoidance or line following, for obstacle avoidance you can place this module in front of the sender /receive diodes that will cause the out pin to be pulled low at distance of 1cm.
Wiring MPU 6050 MEMS Accelerometer GYRO on RPI
Another illustration that demonstrate how to use MPU6050 on Raspberry Pi. The MPU 6050 sensor board contains a MEMS ACCELEROMETER and MEMS GYRO a single chip that provide a very accurate data, as it contains 16bits analog to digital conversion
Wiring the MPU9250 9 AXIS Motion Tracking Micro Electro Mechanical System
The MPU925 is a motion tracking device or MEMS (Micro Electro Mechanical System). A SIP (System in a Package) combining two components the MPU6500 & AK8963. The MPU6500 which is contains 3 axis gyroscope, 3 axis accelerometer, and onboard digital
Wiring the VNH2SP30 30A Monster Moto with MCU
This is essentially common named the monster shield that replace the popular l298n H-Bridge motor driver with a pair of VNH2SP30 a full bridge motor driver, this board is capable of driving a pair of high current motors. The VIN
Wiring a Metal Detector with NPN Proximity Sensor on Arduino
In this illustration we will going to wire the NPN Inductive Proximity Sensor to detect metal or any metal objects, this device also can be used as a metal detector screening when people walking through the entrance to find metal
Wiring the E18-D80NK Infrared Distance Ranging Sensor
In this illustration we will going to wire the Infrared distance switch, a high-sensitive photoreflector to detect distance function, ranging from 3cm to 80cm. When the infrared emitted by the emitter it will get reflected on a surface blocked it
Wiring RFLink 433MHz Remote Controlled Rover Robot
Yet another illustration, this illustration demonstrates making a remote controlled rover robot base on 433MHz RF Link radio module, Joystick and with L298n and l293d H-Bridge motor controller you can choose which suit to use for the motor controller. As
Wiring the GY-NEO6MV2 GPS on Arduino with LCD 16×2 Display
The NEO6 Module is a standalone GPS receiver in high performance UBOX 6 positioning engine. These flexible and cost effective receivers offer numerous connectivity option in small size 16×12.2 x 2.4mm package chip. Their compact architecture and power and memory