Ideas Become Reality
This is the TE 3038, TE 3038 is a type of MEMS (Micro-Electro-Mechanical System) accelerometer that is designed to measure acceleration and tilt. It uses a microelectromechanical system (MEMS) to detect changes in acceleration and converts this into an electrical
POE or Power Over Ethernet is a technology that lets electrical power to be transmitted along with data over standard Ethernet cables. This eliminates the need for separate power cables and power supplies for networked devices, making it a convenient
ATmega32U4 and ATmega16U4 are both MCU from Atmel Corporation (now a part of Microchip Technology), which are based on the AVR architecture. They are similar in many ways, but there are some distinctions between the two. The ATmega32U4 is an
The Texas Instruments ISO1540 and ISO1541 is a high-speed isolated digital output interface IC, designed to provide high-speed, isolated digital outputs for control systems. Like the ISO1540, it is designed to provide electrical isolation, making it suitable for use in
This is ADuM1250 is a digital isolator product manufactured by Analog Devices. It uses a technology called iCoupler to provide electrical isolation between the input and output side of the device, while preserving the digital signal. The ADuM1250 can be
Another project that illustrates how to build a lighting system for Electronic Scooters and Bikes. However, this project also can be applied in car lightning accessories such as under chassis lightning or grill light effects using addressable LED Stripe &
This is the PCA9685 develop by XMP semiconductor. The PCA9685 is an i2C / TWI bus controller capable of driving 16 channels PWM controller. Suitable for driving servos and LED. Each LED output has its own 12-bit resolution at 4096
The DRV8880 is a 2A stepper motor driver with integrated auto tune, support STEP/DIR interface up to 1~16 micro stepping indexer that runs on 6.5 to 45v range. These device can be use in Automatic Teller, Money Handling Machine, Security
The DRV8833 is almost similar to DRV8871 it has also H-Bridge current control motor driver and also can drive a DC Motors and 1 Stepper Motor, solenoids, or other inductive loads. The difference between DRV8833 and DRV8871 is pin configuration
The Texas Instruments DRV8871 is a 3.6A brushed DC motor driver with internal current sense / pulse with modulation control. This device is suitable use for printers, industrial equipment’s, mechatronics, appliances, etc. This device as 2 logic input to control
This is the DRV2605L Haptic Driver for LRA (Linear Resonant Actuator) and ERM (Eccentric Rotating Mass) with effect library and smart loop architecture. This device is licensed version of TouchSense 2200 software from Immersion which eradicates the need to design
Other micro-controller uses 5v as standard input voltage, many latest device modules, popular sensors, GPS, RF modules, Flash Memories, SPI storage, Display, use 3 to 3.3v most of this devices requires logic level conversion to protect them from high voltage