Guide Wiring the 0.95 inch 96×64 RGB OLED Display Module

Wired Developer

7 years ago

This is the 0.95 inch 96X64 RGB 65K OLED Display module, driven by SSD1331 via SPI2 Interface distributed by Waveshare. These device is mainly runs on SSD1331 a single chip CMOS OLED/PLED driver at 288 segment and 64 common output supports up to 96RGB x 64 dot matrix display. SSD1331 chip is designed for common cathode type panel and embedded graphic display data RAM or GDDRAM it supports with 8, 9, 16 bits 8080/6800 parallel interface as well as serial peripheral interface and 256 step contrast and 65K color control logic. This device is suitable used for Mobile Phones, Radio, Mp3 Player, Mp4 Player, Automotive, Home Appliance, and Industrial devices.

Required Components

Arduino Microcontroller, NodeMCU, Teensy Board, TeensyDuino, ESP8266 12, 12E, ESP8266 NodeMCU, ESPDuino, ATMEGA328 16/12, ATMEGA32u4 16/8/ MHz, ESP8266, ATMEGA250 16 MHz, ATSAM3x8E, ATSAM21D, Raspberry Pi, STM32 (Note: The Diagram below is using NANO. (please refer to the respective pin-outs)
SPI 0.95 inch RGB display module
Jumper Wires / DuPont Wires
Solder Less Bread Board (Optional)